home / work / pajero gear hold
Case study · Mitsubishi Pajero 3.0 V6 automatic
A Pajero that holds the gear you chose
Put a 2008 Pajero 3.0 V6 in its manual gate, pick a gear and hold your foot down, and the gearbox shifts up by itself before the engine has finished pulling. I changed that in the factory controller, so manual now means manual.
The complaint
The Pajero's 4-speed automatic has a manual gate with plus and minus. Most owners expect it to hold whatever gear they select. It does not. Near the top of the rev range the gearbox decides for you and shifts up, which is exactly what you do not want on a climb, in sand, or when you are holding a gear on purpose.
It is not a fault. On Pajeros of roughly 2007 to 2011 it is a rule Mitsubishi wrote into the factory software. That also means no workshop can fix it with a repair, because nothing is broken. Owners have been asking about it for years, usually after losing drive halfway up a dune or a climb.
A platform nobody had prepared
This controller runs both the engine and the gearbox, on a Mitsubishi processor that the usual tuning tools do not cover for this unit. Before changing anything I fully decompiled its software, every function: how the gearbox chooses a gear, how it carries out each shift, how the manual gate is handled, and how the engine side limits revs.
That is how the cause was found. The self-upshift is a deliberate rule in the gearbox software, with its own protections around it.
What I changed
- The gear is held. In the manual gate the gearbox now stays in the gear you selected all the way to the rev limiter.
- The limiter was made to suit. Once the gear was held, the factory behaviour at the top was unpleasant: the engine touched the limit, the throttle closed by itself, and the revs sagged and stayed down until the driver lifted. It now sits on a clean, audible limiter at around 6,200 rpm.
The limiter went through several versions in one day, each one judged from the driver's seat. A sharper limiter is planned next.
See it on video
Pajero manual mode now holds the gear
A 2008 Pajero 3.0 V6 automatic holding the selected gear in manual mode right to the limiter, where the factory gearbox shifts up by itself. No new hardware.
Watch on Instagram →What I left alone
The protections Mitsubishi built are still there:
- The gearbox still shifts down by itself as the vehicle slows.
- It still refuses a downshift that would over-rev the engine.
- It still returns to its automatic schedule when the transmission fluid is too hot.
- Drive (D) behaves exactly as it did from the factory.
Next on this platform
Quicker upshifts in manual mode are built and are next to be road-tested. With the controller fully decompiled, nothing on this platform is off limits: shift behaviour, rev limits, throttle response, engine calibration and new functions the factory software never had. See the Pajero platform page.
Have a car the usual tools cannot touch?
Tell me the car, the engine, the gearbox and what you want it to do. I reply to every serious enquiry.