hexandboost

Owner's guide

ECU tuning in Pakistan: what owners ask

Straight answers to the questions I get most from owners here, written by Haris of Hex and Boost in Lahore. Where the honest answer is "not yet" or "it depends", that is what it says.

The basics

What is ECU tuning?

The ECU is the computer that runs the engine, and on many cars the automatic gearbox too. Tuning means changing how that computer behaves: how much fuel and boost the engine gets, when the spark fires, when the gearbox shifts, and what the car does to protect itself. It can be a small change to the factory settings or, as in my work, new functions written into the computer.

What is the difference between a remap, a piggyback and a standalone ECU?

A remap changes settings inside the factory ECU. A piggyback is a box wired between the sensors and the ECU that alters the signals, so the ECU is working from false information. A standalone replaces the factory ECU completely, which usually costs you the factory gearbox control, dash functions and cold-start refinement. I work inside the factory ECU and add to its program, so the car keeps everything Honda or Mitsubishi built and gains the new function.

Is ECU tuning safe for my engine?

It depends entirely on how it is done. The dangerous tunes are the ones that turn down knock protection, relax temperature limits or add a lot of torque low in the rev range to make a big number. A careful tune keeps the factory protections working and adds its own. Ask any tuner which protections stay active, and ask to see logs from the car.

Will tuning reduce the life of my engine or gearbox?

More power always means more load, so the honest answer is that it can if it is overdone. That is why I add protection together with performance, keep torque in check where the gearbox is weakest, and validate from logs. Features that add no power, such as paddle shifting from the cruise buttons or fault codes on the dash, put no extra load on the engine.

Can the car be returned to stock?

Yes. Before changing anything I read the ECU and keep that original file untouched. Writing it back returns the ECU to exactly how it left the factory.

Fuel and conditions in Pakistan

Can a tuned car run on regular 92 RON petrol?

Only if the tune was written for it. A calibration made for higher-octane fuel can knock on 92 RON, which is why factory knock control must never be switched off. My own turbo car's boost maps are written for 95 RON. For any customer car I state which fuel the calibration is written for, and the ECU stays able to pull timing by itself if a bad tank goes in.

Does the heat in Pakistan matter for a tuned car?

Very much, especially on turbo engines. Hot intake air makes knock more likely and a small intercooler heat-soaks quickly in traffic. A tune tested only on a cool evening or a dyno can misbehave in a Lahore summer. My testing is done on the road here, and the logs include intake air temperatures of 37 to 50 °C.

Will ECU tuning improve my fuel average?

I do not promise it. Fuel average depends mostly on how the car is driven, and I have not measured a fuel-economy gain I would stand behind in public. Be careful with anyone who guarantees a number.

Will the check engine light come on after tuning?

It should not on a properly finished job. If a light does come on, the code matters. On my own car I added the ability to read and clear stored codes from the steering wheel, and my own hardware reports its faults as standard codes any scan tool can read.

Warranty, resale and trust

Will ECU tuning affect my warranty?

It can. A dealer who finds the engine computer has been modified may refuse a warranty claim related to the engine or gearbox. The car can be returned to its original file, but I will not promise you that a dealer can never tell. If your car is under warranty, decide with that in mind.

How do I know a tuner is good?

Ask for evidence, not adjectives. Which protections stay active? Which fuel is it written for? Can I see logs of boost, mixture, ignition timing and knock from a car like mine, in local heat? Do I get a log from my own car before and after? Can it go back to stock? A tuner who answers these clearly is a safer choice than one who quotes horsepower.

Does Hex and Boost have customer reviews?

Not many yet, and I would rather say so. What is published is shown with its logs, and results from more cars are being added as they are done.

Do you sell tune files or send tunes by email?

No. I work on a specific car, in person, and I do not sell or share files.

Honda Civic owners

Can I get paddle shifters on my Civic Rebirth without cutting wires?

Yes, on the Civic Rebirth 1.8 automatic with factory cruise control buttons. Manual shifting is written into the car's own ECU, and the cruise RES and SET buttons shift up and down. No paddles, no relay box, no wiring changes, and cruise control still works.

Why not just install aftermarket paddle shifters?

Most paddle installs here tap into the transmission wiring. When one of those joints fails, the result is fault codes and a gearbox stuck in one gear. Doing it inside the ECU leaves the car's wiring exactly as Honda made it.

Can the Civic X 1.8 CVT have manual gears?

Yes. On the Civic X 1.8 CVT I have given the car seven fixed steps in S mode, shifted from the cruise buttons, with no hardware changes. Normal D is unchanged. The instrument cluster on that trim does not show the gear number.

Is the 7-speed mode bad for the CVT?

The steps sit within the range of ratios the CVT already uses, D mode is untouched, and I have not changed the belt pressure or lock-up behaviour. It has been driven and recorded on the road. I do not have long-term mileage data on it yet, and I will publish it when I do.

Can a Civic Rebirth 1.8 be turbocharged on its stock ECU?

Yes. My own Rebirth 1.8 automatic runs a turbo on its factory ECU, which still controls the 5-speed automatic. The ECU was given boost control, a 3-bar pressure sensor, speed-density fuelling, an electronic wastegate and protections that reduce boost on knock or a lean mixture. I do the ECU side; the turbo hardware is fitted by your builder.

How much boost is safe on a stock Civic 1.8 engine?

There is no single safe number, because it depends on fuel, heat, torque and how well the engine is protected. My development car runs 13.5 psi with layered protection, but it is a test car and I accept risks on it that I would not put on a customer's daily driver. For a customer car on stock internals I would recommend less, and decide it from that car's logs.

Can you tune my Civic X 1.5 Turbo?

Yes. I have fully decompiled the factory 1.5 Turbo ECU, and I can read it, write it, calibrate it fully and add custom functions to it. My approach is reliability first: knock control and heat protection stay active, and low-rpm torque is kept in check to protect the CVT. The first customer car is lined up and its logs will be published.

Other cars

Can the Pajero automatic hold gears in manual mode?

Yes, on the 2008 Mitsubishi Pajero 3.0 V6. From the factory it shifts up by itself in the manual gate. I changed the factory controller so it holds the gear you chose to the rev limiter, with the factory protections kept and D unchanged.

Do you tune Toyota Corolla, Honda City, Suzuki, Toyota Fortuner or Hilux Revo, Kia or Hyundai?

Yes, as a new platform. My work is not tied to a list of supported cars. I read the car's ECU, fully decompile its program, and then any customisation is possible: calibration, changed behaviour or new functions. The controllers already fully decompiled are the Honda Civic Rebirth 1.8, Civic X 1.8 CVT, Civic X 1.5 Turbo and Mitsubishi Pajero 3.0 V6, so work on those starts immediately. For anything else, send me the make, model, year and engine.

Do you do ECU repair, key programming, immobiliser work or odometer changes?

No. I do not repair damaged ECUs, program keys, bypass immobilisers or alter odometers. My work is adding functions and calibration to a healthy factory ECU.

Do you fit turbo kits or other hardware?

No. I am one engineer working on the software and electronics side, by appointment, without a walk-in workshop. Mechanical work is done by your own builder, and I work with them on what the ECU needs.

Working with me

How much does it cost?

For my first customers there is no fixed price: you pay what you feel the work was worth. I can do that because I build my own tools and have no software subscriptions or licence fees to recover. It is not a trial of unfinished work. What I offer has already been driven and logged, it is tested before it goes on yours, and your original file is kept so the car can go back to stock. What helps me most in return is your permission to publish the results and an honest review.

Where are you, and do you work with owners in Karachi or Islamabad?

I am based in Lahore and work by appointment. If you are in another city, message me with your car and location and I will tell you what is practical.

How do I start?

Send a message on Instagram to @hexandboost with the car, model year, engine, gearbox, any existing modifications and what you want the car to do.

More about how I work is on the approach page, and the full list of what has been built is on the feature list.

Have a car the usual tools cannot touch?

Tell me the car, the engine, the gearbox and what you want it to do. I reply to every serious enquiry.