home / articles / full-throttle upshifts under boost
Article · Honda Civic Rebirth (9th gen) 1.8 turbo, 5-speed automatic
Full-throttle upshifts under boost on a stock Honda 5-speed automatic
This gearbox was built for a 140 hp naturally aspirated engine. Here is how the stock computer, with my own logic added, takes it through full-throttle shifts at up to 12.7 psi, and what the logs show.
The problem
During an upshift the oncoming clutch has to absorb the engine's inertia while the engine is still making torque. More torque means more slip energy in the clutch. The factory strategy reduces torque by closing the throttle. On a turbo engine at full throttle that is too slow, because the pressure upstream of the throttle is still there.
What the car does now
- Engine torque is reduced for a fraction of a second while the ratio is changing, and brought back as the clutch locks.
- On the hardest shifts a brief cut is added on top.
- Boost control holds still through the shift, so it does not fight the torque reduction.
- Clutch pressure follows the engine's real torque under boost.
The four shifts
- 1 → 2 at 6,404 rpm and 8.3 psi, full throttle. Engine speed falls 2,452 rpm in 286 ms.
- 2 → 3 at 6,426 rpm and 10.7 psi, full throttle. Engine speed falls 2,197 rpm in 276 ms.
- 3 → 4 at 6,318 rpm and 12.7 psi. Engine speed falls 1,787 rpm in 228 ms.
- 4 → 5 at 4,690 rpm and 9.5 psi. Engine speed falls 1,235 rpm in 111 ms.
What the traces show
In all four, engine speed and gearbox input speed fall together through the ratio change and settle on the new gear. Slip during the full-throttle shifts (241 to 255 rpm) stays below the converter slip measured just before them (274 to 286 rpm). There is no flare in the logs.
What is not right yet
- Both full-throttle shifts touch the 6,500 rpm limiter while the next gear is being prepared. The shift needs to be commanded earlier.
- After the full-throttle shifts the mixture sensor reads lean for about 200 ms.
- Boost drops up to 4 psi through a shift and takes time to recover.
Measurement notes
The log rate is 54 ms, so every duration here is good to about one sample either way. Conditions: coolant 88 to 94 °C, intake air 28 to 45 °C, transmission fluid 72 to 79 °C, 95 RON.
The car itself is described in the turbo Civic case study.
By Haris, Hex and Boost. First posted on Facebook.
Have a car the usual tools cannot touch?
Tell me the car, the engine, the gearbox and what you want it to do. I reply to every serious enquiry.